Nomadix HotSpot - Page 117

HOTSPOT GATEWAY
System Administration 103
2. If required, click on the check box for System Log to enable system logging.
When system logging is enabled, the standard SYSLOG protocol (UDP) is used
to send all message logs generated by the HSG to the specified SYSLOG server.
3. Enter a unique number (between 0 and 7) in the System Log Number field. This
ID number is assigned to the System Log Server.
4. Enter a valid IP address in the System Log Server IP field.
5. If required, repeat Steps 2 through 4 for the AAA Log feature.
6. Setting a Log Filter: The syslogs can be filtered at 7 levels as shown above.
Setting the level to a number disables any syslogs above that filter setting. For
e.g. setting the filter to 2:Critical only generates 0:Emergency, 1:Alert and
2:Critical level syslogs. All other syslogs are not generated.
7. Log save to file Setting: This setting enables/disables saving of syslogs
generated by the system to a file named “syslog.txt” in the /flash directory of the
NSE. This setting abides by the other settings set for the syslogs like filters,
number and enable/disable.
It is not required to input a server IP address if you intend to only store the
syslogs locally. Please leave the IP address field blank for such cases.
The following Logs are available for configuration on the NSE
AAA Log
These logs record events related to Authentication, Authorization, and
Accounting on the NSE.
RADIUS History Log
These logs record RADIUS proxy accounting messages sent or received by the
RADIUS proxy. Please refer to “Viewing RADIUS Proxy Accounting History
{RADIUS Session History}” on page 178 for additional configuration
information.
System Report Log
These are Periodic Syslogs <add to index> that report the status of the NSE and
carry information about the NSE ID, NSE IP Address and the current number of
Subscribers on the NSE.
Example:
INFO [nse_product_name version] SYSRPT: ID: 012345 IP: 11.222.333.444
(unresolved) Subscribers: 010
Additional Configuration:
System Report Log Interval
This is the time interval in minutes between the system report syslogs.