HOTSPOT GATEWAY
System Administration 129
3. Enter the SNMP parameters (communities and identifiers), including:
z System Contact
z System Location
z Get (Read) Community
z Set (Write) Community
z Trap Community
z Trap Recipient IP
Your SNMP manager needs this information to enable network management
over the Internet.
4. When finished, you must reboot the system for the new settings to take effect.
Click on the check box for
Reboot after changes are saved? to reboot the
system after saving your changes.
5. Click on the Submit button to save your changes and reboot the system, or click
on the
Reset button if you want to reset all the values to their previous state.
You can now use your SNMP client to manage the HSG via the Internet.
To Next Page
Loading...
