HOTSPOT GATEWAY
Installing the HSG 49
25. Other
Please enter a number from the above list [ 1]:
Select Network Interface Configuration Mode:
0 - Static
1 - DHCP Client
2 - PPPoE Client
Select the Network Interface Configuration Mode: [0]:
Enter network interface IP [ ]:
Enter subnet mask [ ]:
Enter default gateway IP [ ]:
Please enter your ISO country code [US]: US
Please enter your phone country code [1]: 1
Please enter your calling area code [818]: 818
Please enter your network SSID/Zone [ ]:samplezonename
The system must be reset to function properly. Reboot? [yes/no]: y
Your new settings are displayed and the HSG reboots. When the system restarts,
the Telnet interface is enabled (based on your new configuration settings which
are saved to the HSG’s on-board flash memory).
Go to “Logging Out and Powering Down the System” on page 50.
The start up configuration is now complete; however, before connecting
the HSG to the customer’s network, you must power down the system.
To Next Page
Loading...
