HOTSPOT GATEWAY
Installing the HSG 53
3. Follow the on-screen instructions to set up your DHCP options. For example:
Sample Screen Response
Configuration>dh
Enable/Disable IP Upsell [disabled ]:
Enable/Disable DHCP Relay[disabled]:
Enable/Disable DHCP Server[enabled]:
Enter external Subnet-based DHCP Service [disabled]:
IP Upsell Disabled
DHCP Relay Disabled
External DHCP Server IP0.0.0.0
DHCP Relay Agent IP0.0.0.0
DHCP ServerEnabled
DHCP Server Subnet-based Disabled
Server-IPServer-NetmaskStart-IPEnd-IPLeaseTypeIPUp
208.11.0.4255.255.0.0208.11.0.5208.11.0.720PRIVNO
10.0.0.4255.255.255.010.0.0.510.0.0.25030PRIVNO *
* Default IP Pool
DHCP IP Pools Configuration:
0 - Show IP Pools
1 - Add a new IP Pool
2 - Modify an IP Pool
3 - Remove an IP Pool
4 - Exit this menu
Select the DHCP Pool configuration mode[0]:
When assigning a DHCP Relay Agent IP address for the DHCP
Relay, ensure that the IP address you use does not conflict with
devices on the network side of the HSG.
Although you cannot enable the DHCP relay and the DHCP service at
the same time, it is possible to “disable” both functions from the
Command Line Interface. In this case, a warning message informs
you that no DHCP services are available to subscribers.
After setting up your DHCP options, the system must be rebooted for
your changes to take effect.
To Next Page
Loading...
