HOTSPOT GATEWAY
System Administration 71
2. Enable or disable administrator access to any of the following interfaces:
z Telnet
z Web Management
z FTP
3. Click the check box for Access Control if you want to enable this feature, then
click on the
Submit button to save your change.
If you enabled Access Control, administrator access is restricted only to the IP
addresses shown under the “Currently Access is Permitted for IPs” listing. If you
want to add to or remove IP addresses from the list, go to Step 4 through Step 8.
4. To add an IP address (or range of IP addresses) to the list, enter the “starting” IP
address in the
Access Control Start IP field.
5. If you are adding a range of IP addresses to the access control list, you must now
enter the “ending” IP address in the Access Control End IP field. If you are
adding a single IP address, enter “None” in the Access Control End IP field.
6. Click on the Add button to add the IP address (or range of IP addresses) to the
list.
7. To remove an IP address (or range of IP addresses) from the list, enter the
“starting” IP address in the
Access Control Start IP field.
If you are removing a range of IP addresses from the access control list, you must
now enter the “ending” IP address in the
Access Control End IP field. If you are
removing a single IP address, enter “None” in the Access Control End IP field.
Blocking or unblocking interface access will terminate the current
session.
Do not enable the blocking of all interfaces without setting up and
enabling SNMP. Enabling the blocking of all interfaces and
disabling SNMP will completely block access to the HSG
administration interface. For assistance, contact Nomadix Technical
Support.
The Access Control list can contain up to 50 (fifty) valid administrator
IP addresses or up to 50 (fifty) ranges of IP addresses.
To Next Page
Loading...
