HOTSPOT GATEWAY
System Administration 83
10. Enter the DHCP Server Netmask.
11. Enter the starting and ending IP addresses for the DHCP address pool you want
to use:
z DHCP Pool Start IP
z DHCP Pool Stop IP
12. Enter the DHCP Lease Minutes.
13. Select Public Pool or Private Pool, as required.
14. If required, make this an IP Upsell Pool and/or the Default Pool by checking the
appropriate boxes.
15. When finished establishing your DHCP Pools, click on the Back to Main DHCP
Configuration Page
to return to the previous page.
16. You must now reboot the system for the new settings to take effect. Click the
check box for Reboot after changes are saved? then click on the Submit
button to save your changes and reboot the system, or click on the Reset button
if you want to reset all the values to their previous state.
When the system restarts, DHCP is enabled and configured. Skip the remaining
steps in this procedure and go to “Managing the DNS Options {DNS}” on
page 84.
17. The existing lease pool and lease table are deleted and the HSG reboots. The
HSG can issue IP addresses to any DHCP enabled subscriber who enters the
network.
A “public” IP address will not be translated by DAT.
Do not allow pools to overlap.
To Next Page
Loading...
