6
Setting up the PCL driver
6-14 MP1020/1025/1035
Stapling
Multiple-page documents can be stapled.
The staple function is available only when optional finisher is installed.
1 Click the Setup tab.
2 Select the “Staple” check box.
3 From the drop-down list, specify the number of staples and the sta-
pling position.
2
Note
Depending on the selected Binding Position setting, different stapling po-
sitions are available.
Hole punching
Holes can be punched into the printed document.
The hole punch function is available only when punch unit is installed on op-
tional finisher.
1 Click the Setup tab.
2 Select the “Hole-Punch” check box.
3 From the drop-down list, specify the number of punched holes.
To Next Page
Loading...