4
Setting up network printing
4-20 MP1020/1025/1035
Printer driver settings (Windows 98 SE/Me)
When using the Port 9100 to print under Windows 98 SE or Windows Me,
change the printer driver port to the Peer to Peer port.
1 Click the [Start] button, point to “Settings”, and then click “Printers”.
2 Right-click the icon of the installed printer, and then click “Properties”.
3 On the Details tab, click the [Add Port] button.
4 Click “Others”, select “Peer to Peer Port” from the list, and then click
the [OK] button.
The Peer to Peer setup dialog box appears. The printer connected to
the network is automatically detected.
5 Select the printer from the device list, enter the port number, and then
click the “Add Port” button.
–Skip to step 8.
– If the desired printer does not appear in the device list, proceed to
step 6.
6 Click the [Manual Setup] button.
7 Enter the TCP/IP or IPX setting for the network being connected, and
then click the “Add Port” button.
–Skip to step 8.
8 Click the [OK] button on the confirmation screen.
– The port is added.
9 Click the [OK] button on the screen that appears.