8
Setting up the PPD driver (Windows)
8-4 MP1020/1025/1035
Graphics tab
Device Options tab
To specify the following printer-specific options, right-click the printer icon in
the Printers window, and then click “Properties” in the menu that appeared.
You can specify the following options by right-clicking the printer icon in the
Printers window, then clicking “Properties”.
Item Function
Resolution Specifies the print resolution.
Halftone Specifies the halftone number of lines and the pattern angle.
Other Prints a negative or mirror image.
Magnification Specifies the enlargement and reduction ratio.
Item Function
Collate Specifies whether to print multiple copies in sets.
Offset When printing multiple copies, shifts the output position of each
set.
Binding Position Specifies the binding position.
Duplex Specifies duplex printing.
Special Mode Specifies booklet printing.
Staple Performs stapling.
Hole-Punch Performs hole punching.
Center Staple and Fold Folds the printouts in half and staples.
Front Cover Attaches a front cover page.
Back Cover Attaches a back cover page.
Paper Tray (Cover Page) Selects the input tray for the front cover page and back cover
page.
OHP Interleaving Inserts interleaves between overhead projector transparencies.
OHP Interleaving Tray Selects the input tray for the transparency interleaves.
Stop Stops printing temporarily after part of the document has been
printed so that the proof print can be checked.
Item Function
Usable Printer Memory Specifies the memory installed on this machine.
Usable Option Specifies the options installed on this machine.
To Next Page
Loading...
Need help?
General