4
Setting up network printing
4-6 MP1020/1025/1035
Network connection methods that can be selected in each Windows op-
erating system
This chapter describes the settings that must be specified for network print-
ing.
Setting procedures differ depending on the method of networking printing
used (Windows, LPR, or IPP printing). Select the best method of network
printing for your Windows environment.
Network printing from a Windows operating system.
2
Note
Before setting up network printing, install the printer driver. For details,
refer to “Installing the printer driver” on page 3-3.
To perform network printing, change the printer port for the installed
printer driver to one for a network connection, and then change the set-
tings on this machine as necessary. For an IPP connection, it is neces-
sary to install the printer driver first.
When using Port 9100 to print under Windows 98 SE or Windows Me, the
Peer To Peer Printing Tool must be installed.
Only the PCL printer driver can be used with Windows printing. If network
printing with the PostScript printer driver, use LPR printing or Port 9100
printing.
!
Detail
When using Port 9100 to print under Windows 98 SE or Windows Me and
the MP1020/1025/1035, the required Peer to Peer Printing Tool is auto-
matically installed when the installer is used to install the print driver when
this machine is connected to a network. When the installer was not used,
the Peer to Peer Printing Tool must be installed separately. For details,
Proto-
col used
Win-
dows 98
SE
Win-
dows
Me
Win-
dows
2000
Win-
dows
XP
Win-
dows
NT 4.0
Win-
dows
Server
2003
Windows
printing
TCP/IP,
NetBEUI
++++++
LPR printing TCP/IP oooo
IPP printing TCP/IP oo o
Port 9100
printing
TCP/IP ++oo o
To Next Page
Loading...
Need help?
General