11
Various settings
11-34 MP1020/1025/1035
4 Touch either [Bit Selection] or [HEX Selection], and then specify the
setting.
– To specify Bit selection, touch [Bit Selection], touch [¨] or [Æ] to
move the cursor to the bit to be changed, type in the value using
keypad, and then touch [Enter] on the lower right of the screen.
– To specify Hex Selection, touch [HEX Selection], specify the value
by using keypad and by touching [A] to [F], and then touch [Enter]
on the lower right of the screen.
5 To change the setting for a different mode, repeat steps 3 and 4.
6 Touch [Enter] on the upper right of the screen until the first screen ap-
pears.
To Next Page
Loading...