Oki IP-6620 - Page 18

18
Other precautions
z
Media loses its color and quality with age. Check the media condition and select the media in the best
condition.
z
Cut the media carefully, as paper dust may make irregular surfaces.
z
When adhesive-backed media is applied, some adhesive agent may be left on the platen, which may
cause a media jam. So clean the agent completely with a soft cloth moistened with the neutral detergent.
Available area on media
The available area on media in the scanning direction depends on the media width, the media edge guards
application, and the presence pf the color stripe. With the media edge guards and color stripe applied, the available
area decreases by 34.9 mm on the right and 10.0 mm on the left.
Color stripe :NO
Media edge guards :NO
Color stripe :YES
Media edge guards :NO
Color stripe :NO
Media edge guards :YES
Media width
Color stripe :YES
Color stripe :YES
32.6 mm
27.6 mm
10.0 mm
10.0 mm
10.0 mm
5.0 mm 5.0 mm
5.0 mm
Without mesh printing kit nor wide type media
edge guards for platen sheet
Printable area