Oki IP-6620 - Replacing the Media When the End of the Roll Is Reached; Replacing the Media after a Media Jam; Setting the Media Remaining Length

61
Loading the media
Replacing the media when the end of the roll is reached
When there is no more media on the roll, the printer detects it automatically and displays a message.
However, note that with some media types, the printer may not be able to automatically detect the end of the roll. If
printing continues when there is no more media, the printer may get dirty or malfunction. Be sure to check visually
the remaining length of media.
1
LIFT THE LEVER AND
LOAD THE MEDIA
A message is displayed on the LCD screen.
2
Replace the media following the Procedure to remove the roll media and the Procedure
to load the roll media.
Replacing the media after a media jam
Refer to How to clear a media jam on page 233.
Setting the media remaining length
1
PRINTER READY
01: PAPER/1626mm
Press the MENU button.
2
MENU
2
INFORMATION
Press the Down button to select SET
REMAINING MEDIA.
3
MENU
2
SET REMAINING MEDIA
Press the OK button.
4
>SET REMAINING MEDIA
2
01:000
g
050m
Set the remaining media length and press the
OK button.
>SET REMAINING MEDIA
2
01:050
g
050m
Before printing
Loading the media
Adjustment Maintenance
Advanced
operations
Troubleshooting Menu tree Appendix