221
Advanced operations
Out of ink while printing (LCIS)
You can replace ink bottles (supply ink to the reservoirs) while printing in online state without suspending the print
operation.
When ink has run out, the INK LED goes o. You are advised to follow the message instructions.
1
INK LED goes o.
2
PRINTING...
STANDARD ND BI
XX INK HAS RUN OUT
OPEN THE DRAWER
SUPPLY INK AND
CLOSE THE DRAWER
BOTTLES TO SUPPLY
Lc0: Lm1: C2: Y0: K0: M1
SUPPLYING INK...
PLEASE WAIT
The message appears and a warning beep is
emitted to prompt you to supply ink.
3
Open the LCIS drawer, and replace the ink
bottles.
See Install and replace an ink bottle (LCIS) on page
222.
The warning beep does not stop.
The printer continues to emit the warning beep if there is still no more ink left when the printing nishes.
However, the warning beep does not emit if another error occurs.
Perform one of the following action to stop the warning beep.
- Supply ink that has run out.
- Open and close the LCIS unit drawer.
Opening and closing the LCIS unit drawer temporarily stops the warning beep. However, since the warning beep
will be emitted again if you continue printing without ink, it is recommended to quickly supply ink that has run
out.
Refer to page
page 202
if you want to stop the warning beep from being emitted when you print with no
more ink left.
Before printing Loading the media Adjustment Maintenance
Advanced
operations
Troubleshooting Menu tree Appendix
To Next Page
Loading...
