99
Maintenance
Routine maintenance
A Media installation
1
CHECK MEDIA
FOR WRINKLES
Check that the media is not wrinkled.
If it is wrinkled, either set the media again or feed it up to an
area without wrinkles.
* Printing on wrinkled media may damage the nozzle
surfaces.
B Start maintenance (wiper blades check, capping unit cleaning, cleaning)
Select START MAINTENANCE on the panel and follow the instructions to perform both capping unit cleaning and
cleaning at the same time. You may also perform cleaning independently in this manner.
Performing wiper blades check, capping unit cleaning and cleaning at the same time
CAUTION
To prevent the ink from drying inside the print head’s nozzles:
- Do not leave the printer with the carriage detached from the capping unit.
- Complete the capping unit cleaning operation and cap the print heads within 5 minutes.
1
PRINTER READY
01: PAPER / 1626mm
Press the MAINTENANCE button.
2
MAINTENANCE
2
START MAINTENANCE
Press the OK button.
3
>START MAINTENANCE
2
OK?
Press the OK button to start the operation.
To cancel the operation, press the CANCEL button.
Before printing Loading the media Adjustment
Maintenance
Advanced
operations
Troubleshooting Menu tree Appendix
To Next Page
Loading...
