Oki IP-6620 - When an Error Occurs with Automatic Configuration

113
Maintenance
When an error occurs with automatic conguration
If one of the following errors occurs when executing automatic conguration, try manual conguration or perform
the checks and the actions explained below.
INSTALL WIDER MEDIA
* Automatic conguration is not performed. Nozzle map settings from before the execution are maintained.
Meaning
Media of less than 762 mm (30 inches) is used.
Items to be checked Corrective measures
Check that the media is not less than 762 mm (30
inches).
Use media of 762 mm (30 inches) or larger with automatic configuration.
Otherwise use manual configuration.
MANUALLY CONFIGURE 1
NOZZLE MAPPING
* Automatic conguration is not performed. Nozzle map settings from before the execution are maintained.
Meaning
The amount of light received by the sensors did not reach the reference level.
Items to be checked Corrective measures
Check that the sensors for automatic print
adjustment are not covered with ink mist.
Clean the sensors for automatic print adjustment.
(See Cleaning around the ionizers and the sensors for automatic print
adjustment on
page 139.)
Check that the media is clean. Feed the media until you reach a clean section.
Check that the media is not wrinkled. Reinstall the media or feed the media until you reach a section without wrinkles.
Check that you are not using a media type with a
light reflection rate too low.
Automatic print adjustment may not be possible with some media types. In
such a case, use manual print adjustment.
MANUALLY CONFIGURE 2
NOZZLE MAPPING
* Automatic conguration is not performed. Nozzle map settings from before the execution are maintained.
Meaning
The amount of light received by the sensors exceeds the reference level.
Items to be checked Corrective measures
Check that the media is not wrinkled. Reinstall the media or feed the media until you reach a section without wrinkles.
Check that no external light reaches the sensors. Block the external light or change the printer installation location.
Check that you are not using a media type with a
light reflection rate too high.
Automatic print adjustment may not be possible with some media types. In
such a case, use manual print adjustment.
Before printing Loading the media Adjustment
Maintenance
Advanced
operations
Troubleshooting Menu tree Appendix