Oki IP-6620 - Setting the Media on the Take-Up Reel Unit; Tension and Loose Mode Setting Procedure

62
Loading the media
Setting the media on the
take-up reel unit
Tension and loose mode setting procedure
Two modes, tension mode or loose mode, can be selected for take-up reel unit (TUR) operation.
Usually, select loose mode when printing on vinyl (adhesive-backed) media.
When printing on tarpaulin or other media that does not slide well, use the tension mode if the media tends to shift
on the TUR unit.
Note

The take-up reel unit cannot take up some types of media, even if the printer can print on it.
(E.g. rigid media or when winding inward media in outer take-up mode)
Inner take-up direction cannot be used in loose mode.

Set the outer take-up direction in loose mode or the inner take-up direction in tension mode.
Tension and loose mode setting procedure
Set the mode using TUR MODE in the EDIT MEDIA PRESETS menu.
1
PRINTER READY
01: PAPER/1626mm
Press the MENU button.
2
MENU
2
INFORMATION
Press the Down button to select EDIT MEDIA
PRESETS.
3
MENU
2
EDIT MEDIA PRESETS
Press the OK button.
4
>EDIT MEDIA PRESETS
2
SELECT MEDIA
Press the Down button to select MISC
SETTINGS.