117
Maintenance
E Wiper cleaning liquid check and supply
Supply wiper cleaning liquid with the procedure below in the following cases.
- When a printer message prompts you to do so.
- When you notice that the liquid level is low during a daily inspection. Generally, wiper cleaning liquid should be
supplied approximately once per month.
1
PRINTER READY
01: PAPER / 1626mm
Press the MAINTENANCE button.
2
MAINTENANCE
2
START MAINTENANCE
Press the Down button to select WIPER
MAINTENANCE.
3
MAINTENANCE
2
WIPER MAINTENANCE
Press the OK button.
4
>WIPER MAINTENANCE
2
REPLACE LIQUID
,
Press the Down button to select REPLACE
LIQUID, and then press the OK button.
5
>>REPLACE LIQUID
2
OK?
Press the OK button to start the operation.
To cancel the operation, press the CANCEL button.
6
OPEN COVERS, REPLACE
WIPER CLEANG LIQUID
Open the front cover, and then the capping
unit cover.
7
Raise the old wiper cleaning liquid bottle a
little and pull out the bottle after making sure
that all the liquid has owed into the printer.
Note
Visually check that the waste ink bottle is not full before
removing it.
Before printing Loading the media Adjustment
Maintenance
Advanced
operations
Troubleshooting Menu tree Appendix
To Next Page
Loading...
