Oki IP-6620 - When Using 2-Inch Tubes

74
Loading the media
When using 2-inch tubes
Optional 2-inch anges can be installed to use roll media with a tube of 2 inches in diameter.
You can use this type of roll media on both the feeding side and TUR side.
Use the procedure below to install 2-inch anges.
1
Remove the R-pin from the 3-inch ange, and
then remove the ange.
2
Pin
Install the 2-in ange.
Notes

Align the pin and the groove in the ange when
installing the new ange.

The new ange may not slide smoothly around the shaft.
Make sure the shaft is inserted completely in the ange.

Pay attention not to lose the R-pin or the pin.
3
Install the R-pin.