77
Loading the media
Procedure to feed the media up to the cut position after printing
Follow the procedure below to cut the media at the end of the print out after printing.
1
PRINTER READY
01: PAPER/1626mm
Press the Down button.
2
FEEDING MEDIA...
STOP AT CUT POS >
+
After the operation panel display has
changed to the screen shown on the left,
keep the Down button pressed and press
Right button.
3
FEEDING MEDIA…
(Automatic feeding ends or is canceled.)
After the operation panel display has
changed to the screen shown on the left,
release both the Down and Right buttons.
The media is fed automatically up to the cut position even if
you release the buttons.
îšš
Press the OK button or the CANCEL button to
cancel automatic feeding of the media.
îšš
Even after canceling automatic feeding of the
media, you can perform steps
1
and
2
again to
automatically feed the media up to cut position.
4
PRINTER READY
01: PAPER/1626mm
îšš
Use the Down and Up buttons if you want to ne
adjust the cut position.
5
(Cut the media.)
Cut the media following the procedure in Cutting the
media on
page 65.
Note
îš‹
The automatic feeding function is disabled in the following cases.
- No media is installed.
- No printing has been performed after installing the media.
- The end of the printout is located before the cut position.
Before printing
Loading the media
Adjustment Maintenance
Advanced
operations
Troubleshooting Menu tree Appendix
To Next Page
Loading...
Need help?
General
