76
Loading the media
4
Grasp both sides of the cutter blade, push
the two hooks securing the blade, and then
remove the blade with the hooks released.
5
Reverse the orientation of the blade and
reinstall it.
Notes
If the media cutter blade gets stuck while cutting, return the cutter blade to the side, remove curls or other causes of the
problem, and then cut the media again by slowly moving the media cutter blade. Do not forcibly cut the media otherwise
the blade may be damaged and lose its cutting performance.
Pay attention not to drop the media cutter blade. If it falls the blade may be damaged and lose its cutting performance.
Handle the cutter blade with care.
It may be impossible for the cutter blade to cut thick media or cloth. In such cases, use a pair of scissors or other adequate
means. Forcibly cutting thick media may damage the media cutter blade and degrade its cutting performance.
To Next Page
Loading...
