8 Screw the antenna into the thread and tighten with your fingers.
9 Route the other end of the coaxial cable through the User Connections Area and under the
AMR Controller. Avoid chafing, straining, or binding the cable.
10
Connect the coaxial cable to the antenna connector on the AMR Controller.
11
Replace the User Connections area cover.
12
Replace the Rear and Right Skins to complete this procedure.
3 Installation
3-47
AMR (Autonomous Mobile Robot) MD-series Platform User's Manual (I681)
3-13 Wireless Antenna Relocation Procedure
3
To Next Page
Loading...
Need help?
General
