3 Remove the Rear Skin.
Refer to 6-11-1 Removing and Replacing Skins on page 6-17 for more information.
4
Disconnect the ribbon cable and the Ethernet cable from the rear of the Operator Panel.
5
Remove 5 screws using T25 star bit from the following locations on the Rear Skin and retain
for reuse.
6
Remove the Operator Panel from the Rear Skin.
7
Place the replacement Operator Panel on the Rear Skin and fasten the 5 screws using the T25
star bit.
8 Connect the ribbon cable and the Ethernet cable to the rear of the Operator Panel.
9 Attach the Rear Skin to the AMR to complete this procedure.
6 Maintenance
6-19
AMR (Autonomous Mobile Robot) MD-series Platform User's Manual (I681)
6-11 Replacing Items
6
6-11-2 Removing and Replacing Operator Panel
To Next Page
Loading...
