Installation and WiringFP2/FP2SH
4 − 9
4.1 Installation
Procedure:
1. Insert the installation tabs on the rear of the unit into the
top of the backplane.
2. Push the unit in the direction of the arrow and install
onto the backplane.
When installing the unit to the backplane, make sure the
retaining hook firmly clicks into place and that the unit
is properly secured to the backplane.
Retaining hook
3. Attach the installation screws and further secure the
unit to the backplane. For the 2 modules type unit, there
are two installation screws.
Unit installation screw
2 modules type unit
T ightening 1.0 to 1.2 N · m
To Next Page
Loading...
Need help?
General
