Table of Figures
FP2/FP2SH
iii
3.2.2 Allocation Example of CPU Backplane 3 − 7.......................
3.2.3 Allocation Example of Expansion Backplane 3 − 10................
3.2.3.1 When Using FP2 Backplane 3 − 10....................
3.2.3.2 When Using FP2 Backplane H Type 3 − 11..............
3.3 I/O Mount Allocation 3 − 13.............................................
3.3.1 Using I/O Mount Allocation 3 − 13................................
3.3.1.1 Example of I/O Mount Allocation 3 − 13................
3.3.1.2 Procedure for I/O Mount Allocation 3 − 14..............
3.4 Automatic Allocation 3 − 15.............................................
3.4.1 Using Automatic Allocation 3 − 15...............................
3.4.1.1 Example of Automatic Allocation 3 − 15................
3.4.1.2 Procedure for Automatic Allocation 3 − 16..............
3.5 Procedure for Clearing Registered Content 3 − 17.........................
3.5.1 Meaning of Clearing Registered Content 3 − 17....................
3.5.2 Clearing Content Using Programming Tool Software 3 − 17.........
3.6 I/O Numbers of Free Slots 3 − 18........................................
3.6.1 I/O Numbers of Free Slots 3 − 18................................
3.6.2 Differences Due to Allocation Methods 3 − 18.....................
3.6.2.1 When Arbitrary Allocation is Used 3 − 18...............
3.6.2.2 When I/O Mount Allocation is Used 3 − 20..............
3.6.2.3 When Automatic Allocation is Used 3 − 21..............
Chapter 4 Installation and Wiring
4.1 Installation 4 − 3.......................................................
4.1.1 Installation Space and Environment 4 − 3..........................
4.1.2 Mounting Method 4 − 6..........................................
4.1.2.1 Backplane 4 − 6......................................
4.1.2.2 Units 4 − 8..........................................
4.1.3 Connecting Expansion Cable 4 − 11..............................
4.1.4 Preparing the Backup Battery 4 − 13.............................
4.2 Power Supply Wiring 4 − 15............................................
4.2.1 Wiring of Power Supply 4 − 15..................................
4.2.2 Grounding 4 − 17..............................................
4.3 Wiring Input and Output 4 − 18..........................................
4.3.1 Input Wiring 4 − 18.............................................
4.3.2 Output Wiring 4 − 21...........................................
4.3.3 Cautions Regarding Units 4 − 22................................
4.4 Wiring the Connector Type I/O Units 4 − 23...............................
4.4.1 Wiring the Connector Type Units 4 − 23..........................
4.4.2 Connecting with Connector for Wire-pressed Terminal Cable 4 − 25..
4.4.3 Connecting the Terminals 4 − 27.................................
4.4.4 Connecting with Flat Cable Connector 4 − 32......................
4.5 Wiring the Terminal Block Type I/O Units 4 − 34...........................
To Next Page
Loading...
