LIFEPAK 20/20e Defibrillator/Monitor Section Contents
Previous Page Table of Contents
Back
Index Next Page
11
Replacement
Procedures
Replacement procedures are a set of detailed instructions for disassembly,
handling, and reassembly of replaceable LIFEPAK 20/20e defibrillator/monitor
assemblies.
Perform an interior inspection whenever the device case is opened for service.
When disconnecting cables and wire harnesses, label the cables and
connections so that they match easily during reassembly (for example, J1, J3,
etc.). See the Interconnect Diagram for additional information.
Note: Within replacement procedures, item numbers in parentheses refer to
parts that are in the section’s Parts List.
Repair Procedures Index
Warnings and Cautions
RoHS Standards
Capacitor Discharge Tool
Using the Capacitor Discharge Tool
Saving the Setup Configuration
Main Assemblies
To Next Page
Loading...
