Physio Control LIFEPAK 20 - Front Case Reassembly

Previous Page Table of Contents Section Contents
Back
Index Next Page
LIFEPAK 20/20e Defibrillator/Monitor Replacement Procedures
Front Case (continued)
Front Case
Reassembly
To reassemble the front case:
1. Install the W02 Speaker Assembly.
2. Install the A05 User Interface PCB.
3. Install the W04 Speed Dial Assembly.
4. Install the A11 Active Display.
5. Install the A15 Elastomer Keypad.
6. Install the AED door (if the device is equipped with a door).
7. Install the front case.
8. Install the top case.
9. Install the A07 Battery.
10. Review the labels parts list and install new labels.
11. Complete the LIFEPAK 20 Device PIP.
Interconnect Front Case View Rear View Main Assemblies
9-32