Physio Control LIFEPAK 20 - Setting the Service Mode Passcode

Previous Page Table of Contents Section Contents
Back
Index Next Page
LIFEPAK 20/20e Defibrillator/Monitor Modes of Operation
Service Mode (continued)
Setting the Service
Mode Passcode
To set a service mode passcode:
1. Select
SET PASSCODE in the SERVICE menu. The SERVICE/SET PASSCODE
overlay appears.
2. Enter a passcode by rotating the
SPEED DIAL to select a number and then
pressing the
SPEED DIAL.
3. When the last digit is entered, the
SERVICE menu appears.
(Continued on next page)
4-13