Physio Control LIFEPAK 20 - Front Case Disassembly

Previous Page Table of Contents Section Contents
Back
Index Next Page
LIFEPAK 20/20e Defibrillator/Monitor Replacement Procedures
Front Case (continued)
Front Case
Disassembly
To disassemble the front case:
1. Remove the front case from the device.
2. Remove the AED door (if the device is equipped with a door).
3. Remove the A11 Active Display.
4. Remove the A05 User Interface PCB.
5. Remove the W04 Speed Dial Assembly.
6. Remove the W02 Speaker Assembly.
7. Replace the front case and continue to Front Case Reassembly.
Interconnect Front Case View Rear View Main Assemblies
9-31