Previous Page Table of Contents Section Contents
Back
Index Next Page
LIFEPAK 20/20e Defibrillator/Monitor Modes of Operation
Manual Mode
Turning On the Device
in Manual Mode
Manual mode enables the user to determine when to deliver a shock.
To configure the device to turn on in manual mode (the default is AED mode):
1. Display the
SETUP menu and select MANUAL MODE.
2. Select
MANUAL ACCESS in the MANUAL MODE submenu.
3. Select the
DIRECT option.
The following table shows all the available power-on options.
If the device is placed in manual mode and then reset to AED mode by pressing
the
ANALYZE button, there are no additional manual mode reprompts or
passcode requests until the device power has been cycled.
Mode/Response Response Description
Manual/Direct Turns on in manual mode; direct access between AED
and manual modes.
AED/Direct Turns on in AED mode; direct access between AED
and manual modes.
AED/Confirmed Turns on in AED mode; confirmation required to enter
manual mode.
AED/Passcode Turns on in AED mode; passcode required to enter
manual mode.
4-2
To Next Page
Loading...
