Polyend Tracker+ - Page 45

45
Polyend Tracker+ Manual
Projects
3
NOTES
▌ CREATING A PROJECT SAMPLE INSTRUMENT LIST
1. Press [Sample Loader] to open the sample browser and instrument list
utility page. Ensure a sample based instrument is previously selected
and and not a synth slot.
2. Navigate to the central ‘Instruments’ window and highlight either an
empty slot or an existing instrument. If an existing instrument is
highlighted it will be replaced by the newly selected choice.
3. Navigate to the left ‘SD Card’ window and highlight either instruments or
samples. Use the [Up] or [Down] or Turn (Jog) to navigate and Press
[Enter] screen button to select folder. Use [Shift] + Arrows to batch
select multiple samples / instruments.
4. With a sample or instrument highlighted in the left window, press the
[Add], 1
st
Screen button. This will add or replace in the selected
instrument slot. Using [Add Next], 2
nd
Screen button will add a sample
and will automatically jump the cursor to the next slot.
5. The memory bar chart will indicate the available project memory in
Tracker+. This will depend on the type and size of samples selected
and may limit the amount of instruments available in the instrument list.
6. Additional samples / instruments can be added. The instruments in the
list will be available to add to a step.
Notes:
• A prompt will be offered if replacing an existing instrument.
• When navigating, the /.. symbol indicates folders and subfolder
with a name. Selecting /.. alone will navigate up a level of the SD
Card folder structure.
• Instruments have a .pti lename.
• The memory bar will show an additional red band (increases
memory usage) or green band (decreases memory usage)
indicating the potential memory impact when highlighting a sample
/ instrument to add. Should this be added to the instrument pool it
will affect the memory usage as indicated by the red/green bar.