80
Polyend Tracker+ Manual
NOTES
Sequencing Steps
5
▌ COPYING AND PASTING STEPS AND STEP RANGES
1. Press [Pattern] to select the Pattern Mode page.
2. Navigate to select a Step. Also Press [Shift] + [Left] or [Right] and
[Shift] + [Up] or [Down] to select tracks and rows.
3. Press [Rec] to switch to recording mode. The step bounding box will
turn red and allow copying of the step or collective step range.
4. Press [Copy/Paste] button. The selected step or step range will be
copied to the clipboard.
5. Relocate the cursor to the rst step in which to paste by using [Up],
[Down], Left] or [Right].
6. Press [Shift] + [Copy/Paste] button. The copied step or step range will
be pasted into the selected step and the relative range. Undo and Redo
can be used if needed.
▌ DELETING STEPS AND STEP RANGES
1. Press [Pattern] to select the Pattern Mode page.
2. Navigate to select a Step. Also Press [Shift] + [Left] or [Right] and
[Shift] + [Up] or [Down] to select tracks and rows.
3. Press [Rec] to switch to recording mode. The step bounding box will
turn red and allow copying of the step or collective step range.
4. Press [Delete/Backspace] button. The selected step, if note or
instrument is selected, will be deleted. If FX1 or FX2 is only selected
then the effect alone is deleted.
5. Note that MIDI values are not be delete when deleting a not, but can be
deleted when the instrument parameter is selected.
▌ COPY / PASTE AN ENTIRE PATTERN
1. Press [Pattern] to select the Pattern Mode page.
2. Hold [Pattern] + [Copy/Paste] to copy the current pattern.
3. Select a new pattern, Press [Pattern] + [Up] or [Down]
4. Hold [Pattern] + [Shift] + [Copy/Paste] to paste into the current pattern.
To Next Page
Loading...
