79
Polyend Tracker+ Manual
NOTES
Sequencing Steps
5
Steps can be added edited collectively too. Select a range within a track or
across tracks to edit.
▌ MANUALLY EDITING A RANGE OF STEPS
1. Press [Pattern] to select the Pattern Mode page.
2. Select the target step to edit. Use [Up], [Down] or Turn (Jog) to scroll
top to bottom. Press [Left], [Right] to select a track. Example Row 1 of
Track 1. The step should be highlighted with the green bounding box.
3. Press [Shift] + [Left] or [Right] to select across tracks and [Shift] + [Up]
or [Down] to select rows in a track and expand the selection range.
4. To select all steps for a track, select the top step on the track to select,
then Press [Shift] + [Up].
5. To select all steps in the pattern, select the top step on a track, then
Press [Shift] + [Up] + [Up].
6. Press [Rec] to switch to recording mode. The step bounding box will
turn red and allow editing of the collective step range.
7. Press [Preview], 5
th
Screen button, to play only the range of selected
steps. Also press a [PAD] to preview.
8. The Jog function will now change the selected parameter when in
recording mode as opposed to purely navigation in normal play mode.
9. Select a parameter to edit. Only existing parameters can be changed.
Any empty parameter slots will not change and remain open.
• To select Note: Hold [Note] + Select, or Tap [Note] to lock.
• To select Instrument: Hold [Instrument] + Select or Tap [Instrument]
to lock selection of parameter.
• To select FX1: Hold [FX1] + Select or Tap [FX1] to lock selection.
• To select FX1: Hold [FX2] + Select or Tap [FX2] to lock selection.
10. Turn (Jog) to adjust the parameter value of the selected parameter
within the step. Selected parameter will be solid coloured red. When
adjusting simultaneous values they will each change relative to the
original value.
To Next Page
Loading...
