Chapter 3: Configuring Your Library
Working With Partitions
152 Quantum Scalar i6000 User’s Guide
Otherwise, the Partitions - Step 6: Configure Drive Firmware
Autoleveling dialog box appears.
Note: The Partitions - Step 6: Configure Drive Firmware
Autoleveling dialog box appears only if the drives are
connected via an FC I/O blades or an Ethernet Expansion
blade. If this dialog box does not appear, the Partitions -
Summary Information dialog box appears instead. See
Step 19 on page 153.
The Partitions - Step 6: Configure Drive Firmware Autoleveling
dialog box enables you to set up drives to participate in autoleveling
operations. Drives are autoleveled whenever they are reset, such as
when the library is power cycled or rebooted.
18 To enable autoleveling for the partition, perform the following
steps:
a From the Drive Type drop-down list, click the type of drives that
you want to list in the table. Listed drive types use the following
format:
<vendor>_<product>_<interface>
To Next Page
Loading...
