Chapter 3: Configuring Your Library
Working With Partitions
154 Quantum Scalar i6000 User’s Guide
Downloading Drive Firmware for Autoleveling
Note: Before you begin the following procedure, make sure that you
have obtained the new drive firmware image from Quantum
technical support and placed it in an accessible location on
your laptop.
1 On the Partitions - Step 6: Configure Drive Firmware
Autoleveling dialog box, click Manage Images. The Manage Drive
Firmware Images dialog box appears.
The library sets aside space for drive firmware. You can load multiple
firmware images. The library screen indicates how much space is
free. Quantum recommends you use the latest firmware available
(as specified in the Release Notes). A check mark in the In Use
column indicates one of the following conditions:
• An autoleveling policy exists that uses this drive firmware
image.
• A pending autoleveling policy exists that uses this drive
firmware image.
• A pending firmware update exists that uses this drive firmware
image.
Under these conditions, you cannot delete the drive firmware
image. If the check box for a drive firmware image is clear, you can
To Next Page
Loading...
