Chapter 3: Configuring Your Library
Configuring Control Paths
Quantum Scalar i6000 User’s Guide 161
5 From the CP Drive drop-down list select the drive you want to
configure as the control path. The primary CP drive you selected is
highlighted in yellow.
6 IN the CPF Mode area, select the radio button for the type of control
path failover you want to configure.
Note: If you want to configure control path failover, you must
have a SNW license with sufficient licensed drive counts to
configure a CPF drive. For more information, see
Configure
Control Path on page 361.
7 Click OK. An Operation in Progress dialog box appears.
8 The control path drive is configured.
To Next Page
Loading...
