Quantum Scalar i6000 - Page 184

Chapter 3: Configuring Your Library
Setting Up the Network Configuration
166 Quantum Scalar i6000 User’s Guide
The current port settings are listed in the Current Port Settings
section. For more information, see
Viewing the Current Network
Port Settings on page 171.
Element Description
In the Host Settings area:
DHCP If Dynamic Host Configuration Protocol (DHCP) is
enabled on your network, do one of the following:
• Select Enable to have DHCP automatically
configure the library network settings. Enable
makes the IP Address, Subnet Mask, and
Default Gateway text boxes unavailable.
• Select Disable to make the IP Address, Subnet
Mask, and Default Gateway text boxes
available for you to manually set the library
network settings.
Library Name The network name that you want to assign to the
library.
IP Address The IP address of the library. This text box is
available only if DHCP is disabled.
Subnet Mask The subnet mask. This text box is available only if
DHCP is disabled.
Default
Gateway
The IP address of the default gateway for your
portion of the Ethernet network. This text box is
available only if DHCP is disabled only for Interface
1.
In the Port Settings area:
Auto Negotiate • Select Enable to have the library automatically
negotiate port speeds. Enable makes the Speed
options unavailable.
• Select Disable to make the Speed options
available for you to manually set the port speed.
Speed The port speed (10, 100 or 1000 Mbps). Speed
options are available only if Auto Negotiate is
disabled.