Ricoh B291 - Page 326

SERVICE PROGRAM MODE TABLES
B291/B295/B296/B297 5-66 SM
5913 102 Print Application Set
This SP prescribes the time interval to expire before the machine shifts to another
application when another application currently holds access control for the
standby mode while there is no key input.
[0~1/1/1]
Mechanical Counter Detection 0: Not detected, 1: Detected, 2: Unknown 5915
Confirms that the mechanical counter inside the inner cover is connected.
Border Removal Area Switching [0~1 / 0 / 1] 5923*
Toggles between two settings that affect the appearance of the pages for border
removal and printed facing pages: (1) Using the original area as the allotted area, or
(2) Using only the copy paper as the allotted area.
0: Original
1: Paper
Feed Clutch Start Timing Adjustment, DFU
5958*
Adjusts the clutch timing to optimize the intervals between fed sheets to reduce
jams in the feed unit.
59581*
Start Timing: Tray 1, 2 [35 ~ 57.5 / 42.5 / 2.5mm] DFU
59582*
Start Timing: Tray 3, 4, LCT 35 ~ 57.5 / 42.5 / 2.5mm] DFU
59583*
Leading Edge Detection [19~34 / 26.5 /2.5 mm] DFU
1st Print Delay Timing [0~60 / 0 / 1 s] 5959*
Sets the amount of time the machine waits to project the latent image onto the
drum after the feed/development motor, main motor, and fusing/feed-out motor
switch on.
This setting allows the drum and hot roller to turn freely in order to allow more time
for cleaning toner and carbon that has accumulated on the hot roller strippers.
Changing this can improve image quality but can also slow down the first print
time. Adjust only when necessary.
Large Capacity Exit Mode 0: OFF, 1: ON 5961*
Selects whether or not all stapled copies are sent to Shift Tray 1 when the Two-
Tray finisher is installed.
8K 16K Paper Mode 0: Off, 1: On.
Switches on/off the use of 8-kai, and 16-kai paper sizes.
If ‘Off’, 8-kai, 16-kai paper sizes are not displayed after pressing the selection key.
If ‘On’, 8-kai, 16-kai paper sizes displayed after pressing the selection key. For this
setting to take effect, “2” must be selected for SP5131.
With “2” (Europe) selected for SP5131, the ADF can select 16-kai LEF. With
SP5962 set for “0” (Off), the nearest size is detected as shown below.
Size Loaded
16-kai SEF 6-kai LEF 8-kai SEF
5962*
Size Detected
B5 SEF B5 LEF B4 LEF
5963 Power Consumption Reduction Mode DFU
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA