91
6. Open the top cover again and close the cover for the place where the wireless LAN/
Bluetooth kit is to be installed.
• If the cover does not close, open the top cover to an angle of 50° or less, pull out the
wireless LAN/Bluetooth kit, and redo the procedures from step 4.
7. Close the top cover.
Push both ends of the top cover, and close it firmly until it clicks.
• When closing the top cover, be careful not to pinch your fingers.
•
If the Wi-Fi icon ( ) and the Bluetooth icon ( ) icon do not appear in the Settings
menu, try again.
• After installation, check that the printer is functioning properly and put the sticker that
came with the wireless LAN/Bluetooth kit on the back of it.
To Next Page
Loading...
