Start-up - Cleaning work
4 - 3
830 / 07.2012 Original operating instructions
4.2 Cleaning work
ATTENTION
Comply with the safety instructions before starting tasks.
CAUTION
Clean the machine daily.
For heavy contamination, clean the machine several times per day
if necessary, especially in recycling applications.
Ensure that the cleaning agents used do not damage the seals and
components of the machine.
Do not use aggressive cleaning agents.
Only use lint-free cleaning cloths.
Only use dry, filtered compressed air up to max. 2 bar (29 psi).
Lubricate the lubrication points after every cleaning.
Replace protective caps on the lubricating nipples.
After cleaning the engine compartment, check all lines for leaks,
loosening or damage and correct any problems.
Risk of condensation
After a wet cleaning, check that there is no moisture in the electrical
control cabinet.
On completion of cleaning work on the machine, carry out a visual
and functional check according to the machine operating
instructions.
WARNING
Electrical and electronic components such as the alternator, control
cabinet etc. as well as the bearings of the elevating cab (may cause
failure in the bearing surfaces and result in sudden, uncontrolled
motion when positioning the cab) must never be subjected to a direct
stream of water!
Wet cleaning of these components is prohibited!
When wet cleaning the machine, always make sure that no water/
moisture comes into contact with electrical or electronic components.
Water infiltration can otherwise damage or destroy the machine
electronics. This can result in sudden, uncontrolled operating
movements.
To Next Page
Loading...