Start-up - Switching the machine off
4 - 38
830 / 07.2012
Original operating instructions
4.11 Switching the machine off
4.11.1Switching the engine off
Note
Switching off the driving engine without allowing a cooling down phase
may cause heat storage and overheating of engine parts and especially
the turbocharger. Therefore, allow the drive engine to cool down before
switching off:
Lower the engine speed to approx. 50% of the nominal speed
(see Chapter 4).
Allow the machine to run for an additional 5-10 minutes.
Non-observance may cause increased wear to the engine and cooling
system!
1 Park the machine on a firm subgrade.
2 Place the attached loads and the boom on the ground if
necessary.
3 Lower the engine speed to 50% of the nominal speed in order
to prevent damage to the engine and cooling system.
4 Allow the engine to run for approx. another 5-10 minutes.
5 Slow the engine to idle.
6 Turn the ignition key to the “0” position and remove.
7 Pull back the safety lever.
8 Secure the machine (lights, warning triangle, chocks, etc.).
To Next Page
Loading...