Start-up - Switching on machine
4 - 34
830 / 07.2012
Original operating instructions
4.10.4Starting the engine
DANGER
Danger of poisoning!
Only run the engine outdoors or in well-ventilated areas. Inhaling
exhaust gases is hazardous to your health. It may lead to loss of
consciousness and death.
Control panel,
right
“Wait to start” lamp
in SENCON
The “Wait to start” symbol in SENCON shows the driver that he should
wait until the symbol goes out before starting the engine.
1 Perform daily inspections in accordance with Section 4.5.
2 Insert the key into the ignition lock (2) and turn to position “I”.
– The engine speed, refrigerant temperature and fuel level
are now indicated on the SENCON display (3).
3 Start the engine — option 1:
– Turn the ignition key (2) to position “II”.
Start the engine — option 2:
– Start the engine — press the button (4).
4 Set the desired engine rpm using the rotary knob (1).
To Next Page
Loading...