Safety - Safety instructions
1 - 25
07/2012
Original operating instructions
Lightning Cabs on construction equipment are equipped with protection against
lightning strikes. The lightning current flows through the cab to ground.
DANGER
Do not touch any metal parts that make direct contact with the
chassis during storms.
The electromagnetic field connected with lightning current can affect
sensitive electronic components and could lead to malfunction or
complete failure in certain circumstances.
Before putting the machine back into operation, ensure the
operating instruments and safety elements are working properly.
The enormous amount of heat can cause extensive damage to tires
(depending on the type of machine).
Before recommissioning the machine, check all subassemblies for
damage and perform a functional test.
1.9.2 Cleaning work
CAUTION
Clean the machine daily.
For heavy contamination, clean the machine several times per day
if necessary, especially in recycling applications.
Ensure that the cleaning agents used do not damage the seals and
components of the machine.
Do not use aggressive cleaning agents.
Only use lint-free cleaning cloths.
Only use dry, filtered compressed air up to max. 2 bar (29 psi).
Lubricate the lubrication points after every cleaning.
Replace protective caps on the lubricating nipples.
After cleaning the engine compartment, check all lines for leaks,
loosening or damage and correct any problems.
Risk of condensation
After a wet cleaning, check that there is no moisture in the electrical
control cabinet.
On completion of cleaning work on the machine, carry out a visual
and functional check according to the machine operating
instructions.
To Next Page
Loading...