sennebogen 830 E - Safe Entry and Exit

Safety - Safety instructions
1 - 27
07/2012
Original operating instructions
1.9.3 Safe entry and exit
 If necessary, clean access ladders and ladders prior to use.
 Enter or exit machine only when stationary and after the cab has
been lowered completely — never — during any motion.
 Do not carry any items when climbing up or down.
 When entering or exiting, always ensure that you have three points
of contact on the access ladders, ladders and grip handles. (e.g. two
hands and one foot or two feet and one hand)
 Hoist items of equipment onto the machine using rope or lifting
equipment.
 Do not use operating instruments in the cab as grip handles.
 Use only the appropriate, provided access ladders and/or ladders.
 When the cab is raised, entering and exiting the cab/gallery is not
permitted.
 At working heights of 2.00 m or more, SENNEBOGEN recommends
the use of a safety harness to prevent falling. At working heights
above 3.00 m, using a safety harness is required legally.
Hanging rings are marked.
Cab without gallery
1 Open the sliding door (1) from the ground.
2 Hold onto the grip handles (2) and use your feet to step on the
access ladders (3) and climb into the cab.
3 Close the sliding door.