sennebogen 830 E - Refueling the machine

Operation - Refueling the machine
6 - 86
830 / 07.2012
Original operating instructions
6.6 Refueling the machine
The machine can be refueled in two ways:
 Manually
 Using a refueling pump/refueling pump (mast).
DANGER
 Fuel is damaging to health and easily inflammable.
Smoking or an open flame is strictly forbidden.
 Position the machine on a firm, even subgrade.
 Only refuel when the engine is shut down.
 Fuel must not ingress ground or waterways.
Always ensure that no fuel overflows during refueling.
 Before filling, the fluid level in the tank must be determined, and thus
how much more fuel the tank can hold.
 When refueling from a tanker: the maximum filling speed is 200 l/min.
(52 US gpm); if the filling speed is any higher, the fuel will overflow.
 The filling procedure must be monitored at all times, no matter how
the filling is done.
Note
Observe the notes in the operating instructions of the engine
manufacturer.