sennebogen 830 E - Intended use

Safety - Intended use
1 - 2 07/2012Original operating instructions
1.2 Intended use
Intended use of the machine consists solely of hoisting, transport and
loading of loads. Permitted attachments are:
 grab
 Magnet units.
In addition, in special cases:
 scrap shears
 Demolition hammer
 Concrete crusher
Attachments An overview of all of the attachments that are currently available
including matching machine types can be found in the appendix.
WARNING
Not every attachment is suitable for every type of machine. Only the
attachments (type of construction and size) that are approved for the
respective type of machine are to be attached.
If any other attachment not listed is mounted, the user/operator is
responsible.
Observe the performance specifications of the machine. Lifting
capacities are not to be exceeded under any circumstances.
Other or additional applications are considered not
in accordance with
its intended use and can endanger persons or machinery.
Work station The machine operator’s work station is in the cab of the machine.
Target group The machine has been developed for demanding work.
Persons working on or with the machine must be trained or instructed
for that purpose. Start-up, maintenance, transport, and assembly/
disassembly should only be performed by trained specialists.
 Load hook:
When working with the load hook, the machine that must be used,
in accordance with DIN EN 474-5, is an excavator used as a hoist.
For this purpose, the machine must be fitted with a load torque
monitoring device, which cuts out in the event of overload. The
lifting cylinders must be fitted with cable break safety devices.
Before commencing work in the hoisting operation, please check
the equipment on your machine and consult SENNEBOGEN
Customer Service if necessary.
 Trailer:
The machine is suitable for pulling a trailer but is subject to the
permitted axle load. Questions should be directed to
SENNEBOGEN Customer Service.