sennebogen 830 E - Operation; Safety instructions

Operation - Safety instructions
6 - 1
830 / 07.2012
Original operating instructions
6 Operation
6.1 Safety instructions
DANGER
 Please read Chapter 1 Safety.
Before start-up, please carry out checks in accordance with
Section 4.5.
 Persons working on or with the machine must be trained or
instructed for that purpose. Operation and work application may only
be carried out by trained personnel.
 The following applies for all work:
Only carry out work if the subgrade is firm and even and solid
enough.
 Proceed with the utmost caution if you bypass the stick end limitation
or other safety shutdowns.
 Ensure that there is no one in the danger area.
 Maintain safety clearance to overhead power lines.
 Only operate the machine from the driver's seat.
 When switching the attachment (e.g. grab), release the pressure
from the hydraulic system.
 Do not transport persons on the machine.
 Take environmental conditions into account, e.g. poor visibility, wind
speeds etc.
 Use the specific lifting capacity tables for the machine.
 Note performance specifications.
 Check that attachment points have a sufficient safe working load.
 Observe banksman signals if they are given.
 If visibility is poor, ensure that a banksman is used for giving the
required signs when reversing.
 Before moving onto ramps or inclines, make sure you obtain the
maximum permitted values from SENNEBOGEN.
 Position the boom in the travel direction during long journeys.