Start-up - Starting up operating again
4 - 42
830 / 07.2012
Original operating instructions
4.14 Starting up operating again
Proceed as follows if you want to put the machine back into operation:
4.15 Disposal
Please contact SENNEBOGEN After Sales should you need to dispose
of the machine.
1 Remove the anti-corrosion agent using a suitable method, e.g.
with a pressure washer and the respective cleaning additives
(be careful around sensitive and electronic components!).
2 All uncoated surfaces and bearing points must be oiled or
greased according to the service measures and the lubrication
plan diagram.
3 Prepare the diesel engine for operation. Observe the
instructions in the engine manufacturer operating manual.
4
Check oil levels for sufficient fill quantities (e.g. hydraulic
system, drive engine).
5 Check the antifreeze fill level and mixture in the cooling
system.
6 Check the machine thoroughly for leaks.
7 Check the entire machine (equipment, undercarriage, etc.) for
damage.
8 Install the LCD displays again if necessary.
9 Check that all safety features (brakes, signal and lighting
equipment, etc.) are working properly.
10 Investigate hazardous areas at the work site, identify them and
secure sufficiently.
11 Align the machine horizontally.
12 Warm up the machine sufficiently before work application. See
Chapter “Bringing the machine to operating temperature”:
To Next Page
Loading...