sennebogen 830 E - Work application

Operation - Work application
6 - 44
830 / 07.2012
Original operating instructions
6.5 Work application
6.5.1 Safety instructions
DANGER
 Please read Chapter 1 Safety.
Before start-up, carry out checks in accordance with Section 4.5.
 Persons working on or with the machine must be trained or
instructed for that purpose.
Operation and work application may only be carried out by trained
personnel.
 Proceed with extreme caution whenever you bypass the limit position
sensor for the arm.
 Ensure that there is no one in the danger area.
 Maintain safety clearance to overhead power lines.
 Only operate the machine from the driver's seat.
 Do not transport persons on the machine.
 Take environmental conditions into account, e.g. poor visibility, wind
speeds etc.
 Use the specific lifting capacity table for that machine.
 Note performance specifications.
 Check that attachment points have a sufficient safe working load.
 Observe banksman signals if they are given.
 Never allow the machine to roll with the ignition switched off. When
the engine is not running, there is no power-assisted steering.
 Position the boom in the travel direction during long journeys.
 Before leaving the cab:
– Park the machine on a firm subgrade. If necessary, move back
from the edge of the excavation
– Lower attached loads
– Secure equipment
– Pull the safety lever back
– Chock tires/undercarriage
– Switch off the engine
– Lock the cab, show warning lights if necessary
– Lock the floating axle.