Operation - Additional displays (optional equipment)
6 - 43
830 / 07.2012
Original operating instructions
Heater for
water separator
(optional)
The machine is equipped with a heated water separator (1).
In order to activate the heating system for the water separator (1),
activate the switch (2) in the right-hand control panel.
1 Start the engine in accordance with Section 4.10.4.
2 Switch on the heating system for the water separator with
switch (2).
– The pilot lamp in switch (2) lights up until the fuel has
achieved operating temperature (=thermostat).
To Next Page
Loading...